P&M Industrial Finishing Company P&M Industrial Finishing Company P&M Industrial Finishing Company
Contact Us Site Map Home
About Us
Finishing Process

      Pre-Treating
      Processes


      Bulk Coating

  » Spray Coating

      Powder Coating

      Decorating

Service Area
FAQs


Request a Quote
Finishing Processes
Spray Coating

Liquid Coatings Offered

 Alkyds

 Urethane

 Epoxies

 Polyester

 Enamels

 Lacquers

 Epoxies

 Military
 Specification


 Automotive
 Specification


 Full range of colors
 and textures

   - Air Dry
   - Baked
   - Catalyzed
   - Water Borne
   - Solvent Based


Electrostatic Powder Spray Conveyor System
Electrostatic Wet Spray

A coating method in which the liquid paint is given an electrostatic charge with a specialized gun and power pack so that the paint is attracted to a grounded part that is to be coated. The paint adheres to the part using the electrostatic charge until the paint is cured. Finishes utilizing this method are available in a variety of colors and textures. This type of spraying can be applied either manually or automatically.

Types

Conveyor
This system utilizes a wet spray booth and a curing oven connected by an overhead conveyor. Parts are hung on racks and conveyor. These parts are carried to the spray booth by conveyor for coating either manually or automatically and then to the oven for curing if necessary. The conveyor chain speed for is variable from 1 to 16 feet per minute to accommodate part size, mass and paint curing specifications.

Chain On Edge Spindle
A coating method utilizing electrostatic spray and an inverted conveyor with fixtures to hold parts. Paint is applied to the exterior of small parts on a machine that spins the parts in front of spray guns. Next, the parts are carried into an oven for curing and then through a cooling-off tunnel before the parts are removed manually or blown off. This application is ideal for deep-drawn parts at a cost much less than rack or screen coating.

Powder Spray System
Rack
Parts are hung and hand sprayed. This method normally is used for small runs and coatings, which do not lend themselves to electrostatic spray.

Screen
Parts are laid on screens and hand sprayed. This method normally is used for small runs, coatings which do not lend themselves to electrostatic spray and parts that cannot be hung.

Electrostatic Powder Spray — See Powder Coating


About Us | Finishing Processes | Service Area | FAQs | Contact Us | Site Map | Home

P&M INDUSTRIAL FINISHING COMPANY

1891 Watertown Avenue
Oakville, CT 06779
Toll-Free: 1-800-927-8285
Phone: (203) 755-7212
Email: sales@pmfinishing.com
Fax: (203) 573-8207

Web site developed by Innovative Internet Marketing Solutions